Tesla Model X (All Years Up to 2021) - HEPA Filter

Vendor:Ohmmu

Tesla Model X (All Years Up to 2021) - HEPA Filter

$179.00

The Ohmmu Tesla Model X HEPA Air Filter delivers hospital-grade air filtration for your Tesla Model S — engineered to outperform the OEM filter in every measurable way, with a smarter design that's better for your wallet and the planet.

It's designed with more pleats, providing a greater surface area to trap harmful contaminants, as well as an additional final stage Activated Carbon filter on the back for removing VOCs, gases, allergens, and odors.

Our filters also offer an environmentally-friendly and cost-effective solution to Tesla's OEM filters, which require throwing away the entire plastic filter housing with each filter swap. Our filters reuse this assembly using a foam surround for a tight seal and less waste.

Key Features

Superior filtration, inside and out — Most cabin air filters stop at the basics. The Ohmmu HEPA filter goes further with a two-stage filtration system built to capture what others miss:

  • Stage 1 — MERV-17 HEPA media: More pleats than the OEM filter means greater surface area, higher airflow, and 99.9%+ particle capture at 0.3 microns — trapping dust, pollen, bacteria, smoke, and fine particulate matter
  • Stage 2 — Activated carbon layer: A final-stage activated carbon backing removes VOCs, exhaust gases, allergens, and cabin odors that HEPA alone can't catch

Note — This doesn’t enable BioWeapon Defense Mode in your vehicle if you don't already have the feature firmware from Tesla, but will still filter outside air coming into the vehicle.

Filter Specs

Filtration rating — MERV-17

HEPA efficiency — 99.9%+ @ 0.3 microns

Final stage — Activated carbon VOC and odor removal

Housing — Filter media only, reuse existing plastic housing

Seal — Precision foam surround

Vehicle Compatibility

Tesla Model X — All Years Up to 2021

Tesla P/N — 1045566-00-G, 1045566-00-H

Install Guide

Model X Filter Install Video

To upgrade where there is no filter installed in the housing, simply insert your new filter into place. The foam edges create an air-seal with the housing.

To replace an existing filter, you will need to remove the old filter from its plastic housing. The sides may be glued in, in which case you need to cut out and remove the old filter and glue prior to installing ours.

In most cases, there is only a small amount of glue holding the filter in place and it's a very simple and quick process, however there are instances where a lot of glue was used (usually on older filters) and the process will take 10-15 mins. Luckily, once this process is complete, all future filter swaps will be as simple as pulling out the old filter and inserting the new one -- at a cost savings and producing a lot less waste!

In stock, ready to ship

Pairs well with

In stock! Ships within 1 business day.

Free US based support.